Leather Kitchen Accessories: How to Make a Leather DIY Potholder

  |   4 comments

leather-potholder-diy-5

I had some leftover leather strips from the DIY leather frames project a while back, so I made a DIY leather potholder / heat pad to protect surfaces from hot items in the kitchen and dining room.

I love kitchen accessories, especially with all the things we’ve been cooking up lately. So, this little leather project made perfect sense.

leather-heat-pad-potholder-1

Want to make one? Here’s what you’ll need to make your own…

Materials:

  • leather strips (mine are 1 1/2 inch wide and from Amazon)
  • sharp blade or boxcutter
  • leather hole punch
  • thick thread or string
  • needle with wide enough eye for string to fit through
  • mini clamps

how-to-make-aleather-pot-holder

Instructions:

Start by measuring and cutting 8 strips of leather that are all the same length. I measured each piece of leather to 11 inches for my pot holder.

Next, weave the pieces together with your hands – 4 across and 4 down – under over, under over. You should have excess length on all sides of the pot holder, which will be cut off later.

Use mini clamps to hold the strips together, once you’ve pulled them together as tightly as you can, with your hands.

Next, using a hammer and nail, poke two holes about 1/2 inch apart from each other on each (outer edge) square of leather (all the way through both layers), as shown in the photo. This will be your guide for the larger holes, so you want to make sure the nail goes through both layers.

Number the strips on the underside of the leather before the next step, so that you can put them back together easily later.

Use your leather hole punch to poke larger holes through all of the nail holes. You’ll need to disassemble the woven pattern to do this.

Put the leather strips back together, how they were before you poked the holes with the hole punch. Then use a long piece of thread or string and a needle to thread through all of the holes, all the way around the perimeter of the pot holder / heat pad. Tie off the end underneath with a double or triple knot and cut off excess string.

Then, using a straightedge, cut off excess edges, all the way around the perimeter, for a clean look. Add a hoop string to the finished piece if desired, for easy hanging. All done!

leather-potholder-diy-6

leather-potholder-diy-2

Photography by Amelia Tatnall and Brittni Mehlhoff

Think you’ll give this project a try? What do you think of leather kitchen accessories? Yay or nay?

4 comments | Click here to reply

This is such a cool idea, now I know what to do with my leftover leather scraps!
http://www.makeandmess.com/
Michelle recently posted..Wrapped and Embellished Headphones

Michelle | February 18th, 2016 at 9:48 am

Thanks Michelle!

Brittni | February 18th, 2016 at 10:42 am

This is such a a brilliant idea, I love it! I could make one out of old belt
Marwa | Enthralling Gumption recently posted..What’s enthralling this Friday vol #2

Marwa | Enthralling Gumption | February 20th, 2016 at 5:21 pm

[…] Woven leather trivet — Paper & Stitch […]

100 Gift Ideas You Can DIY Idle Hands Awake | December 4th, 2017 at 12:03 pm
Leave a reply

CommentLuv badge